7.1 Analog Set-up
The diagram shows how to connect a 7.1 SDDS™ analog
The Centre monitor is set as the System Controller by leaving out the TC Link button on the rear panel.
RJ45 Network connections for the system should be connected in the following way: -
Centre output to LF input Centre output to RF input LF output Sub input Sub output to LI input LF output to LS input
LI output RI input
RF output to RS input
The Centre monitor receives audio for both centre (input 1) & LFE channels (input 2) via the analog input connectors.
The LF monitor receives audio for both LF (input 1) & LS channels (input 2) via the analog input connectors.
The LI monitor receives audio for both LI (input 1) & RI channels (input 2) via the analog input connectors.
The RF monitor receives audio for both RF (input 1) & RS channels (input 2) via the analog input connectors.
When no Bass management is selected, only the LFE signal will be sent to the subwoofer.
When Bass management is selected, low frequency content from the 5 main channels is extracted and sent to the subwoofer where it is summed with the LFE channel. (Only LF, Center, RF, LS, and RS contribute to the bass management signal.).
The iDP™ Remote, iDP SOFT™ or
! REMEMBER – To set a master monitor as the system controller the TC Link button on the rear panel MUST be in the out position.
7.1 Digital Set-up
The diagram shows how to connect a 7.1 SDDS™ digital
The Centre monitor is set as the System Controller by leaving out the TC Link button on the rear panel.
RJ45 Network connections for the system should be connected
in the following way: - |
|
Centre output to LF input | LF output to LS input |
Centre output to RF input | LI output RI input |
LF output Sub input | RF output to RS input |
Sub output to LI input |
|
The Centre monitor receives audio for both centre & LFE channels via the AES input connector (input 2).
The LF monitor receives audio for both LF & LS channels via the AES input connector (input 2).
The LI monitor receives audio for both LI & RI channels via the AES input connector (input 2).
The RF monitor receives audio for both RF & RS channels via the AES input connector (input 2).
When no Bass management is selected, only the LFE signal will be sent to the subwoofer.
When Bass management is selected, low frequency content from the 5 main channels is extracted and sent to the subwoofer where it is summed with the LFE channel. (Only LF, Center, RF, LS, and RS contribute to the bass management signal.).
The iDP™ Remote, iDP SOFT™ or
! REMEMBER – To set a master monitor as the system controller the TC Link button on the rear panel MUST be in the out position.
21
