Tannoy ACTIVE STUDIO MONITORS owner manual Monitor Assignment, Calibrate Main Monitors

Monitor Assignment

Task

Press monitor symbol to activate pink noise test-tone.

Then select task for the monitor now playing the noise. Serial number and type will be indicated.

A monitor marked with a question mark indicates that an “unknown” monitor has been detected. (This icon is darker in colour than the previously mentioned ‘monitor not found’)

Scan System

Press the magnifying-glass to scan the entire system for connected units.

Save Settings	- All settings except “preset settings” are saved to a back-up file.
Load Settings	- Press and browse to select file to load. Follow the instructions.

Calibrate - Main Monitors

Pink Noise

Solo

Mute

Parameters and settings for the Main monitors are controlled in this screen

The screen is accessed via the Main Screen by holding the cursor above the desired monitor and selecting the hammer icon.

Room position

Range: Neutral, Wall, Corner, Console, C. Wall or C. Corn

Select according to the actual position of the monitor.

X Curve

Range: Off, X-Curve 1 or X-Curve-2

Two modifications of X-222 curve are available.

See page 51.

39