Analog Stereo Set-up With Stereo Subs
The diagram shows how to connect a stereo set-up with two subwoofers.
The Left monitor is set as the System Controller by leaving out the
TC Link button on the rear panel.
The Left master monitor receives both the left and right input signals
via the analog input connectors.
The Right monitor and Sub receive audio and control via the output
RJ45 TC Link connections on the Left (system controller) monitor.
When no Bass management is selected, no signal will be sent to
the subwoofers.
When Bass management is selected, low frequency content from the
left channel is extracted and sent to the left subwoofer. Low frequency
content from the right channel is extracted and sent to the right
subwoofer.
The iDP™ Remote, iDP SOFT™ or PC-iP™ can be connected to any
spare TC Link “out” connection.
! REMEMBER – To set a master monitor as the system controller the
TC Link button on the rear panel MUST be in the out position.
Stereo Digital Set-up With Mono Sub(s)
The diagram shows how to connect a digital stereo set-up with
one subwoofer. If you are using a standard stereo set up (no subwoofer)
then simply omit the subwoofer.
The Left monitor is set as the System Controller by leaving out the
TC Link button on the rear panel.
The Left monitor receives both the left and right input signals via the
AES input.
The right monitor and Sub receive audio and control via the output
RJ45 TC Link connections on the Left (system controller) monitor.
When no Bass management is selected, no signal will be sent to the
subwoofer.
When Bass management is selected, low frequency content from the
left and right channels is extracted and sent to the subwoofer.
The iDP™ Remote, iDP SOFT™ or PC-iP™ can be connected to any
spare TC Link “out” connection.
If using stereo subs connect in the same way as 2.2 analog.
! REMEMBER – To set a master monitor as the system controller the
TC Link button on the rear panel MUST be in the out position.
17