Master Unit, Slave/Subwoofer | Tannoy ACTIVE STUDIO MONITORS

Master Unit

1.System controller/slave switch.

In the “out” position the monitor operates as a System Controller.

*There can only be one system Controller in a setup. In the “in” position the monitor operates as a regular master or a slave unit.

2.RJ45 link connectors for downstream slave units, remote and PC control.

3.Analogue Inputs.

4.AES/EBU Digital Input

5.Word Clock BNC Sync

6.Power Input 100-240v and Power ON/Off Switch.

5

Slave/Subwoofer

1.RJ45 Link Connections for downstream slave units, remote and PC control.

2.Power Input 100-240v and power ON/Off Switch.

Optional Digital I/0 Card With this card installed in the master monitor. Analogue input slot a 5.1 Digital/ 6 Master setup becomes an option. Three AES/EBU connections (6ch) can then be fed to one master monitor and distributed downstream. See the”setups” section for further information.

2

1

2

3

4

5

1

13

Image 13

Tannoy ACTIVE STUDIO MONITORS owner manual Master Unit, Slave/Subwoofer

Contents

Owners M a N U a L Page Important Safety Instructions Important Safety Instructions Quick Setup Guide T I V E S T U D I O M O N I T O R S Introduction Tannoy Dual Concentric Concept & Design Philosophy Unpacking & Visual Checks High efficiency compact Switched Mode Power Supply SmpsTannoy WideBand SuperTweeter Preliminary Recommendation Speaker PlacementOrientation Master & Slave Concept Slave Monitor & Subwoofer Remote ControlInitializing the Network IDP Soft Software Remote Slave/Subwoofer Master Unit SUB IDP Display Master General Setup Procedure General Setup Procedure SetupsAnalog Stereo Set-up With Mono Subs Stereo Digital Set-up With Mono Subs Analog Stereo Set-up With Stereo Subs Digital Set-up Analog Set-up Digital 192kHz Set-up Digital Set-up Analog Set-up Analog, Digital& 192kHz Alternative 7.1 Set-up Connecting Three Subs Connecting Two Subs Stereo Set-up With Chains on L&R. Analog or Digital Dig/6 Master Setup when the monitors are connected Reset All Settings Reset ProcedureSelect Setup Select Monitor Tasks Parameter Description Press Enter to access the Select ModeMain Display † PC-iP Bass Management PhaseLFE Low Pass Filter LFE Gain Setup Setup MenuSet Monitor Task External Clock LFE channel important Parameters available for the subwoofer Parameter Categories IDP Remote Volume potentiometer Preset 1/3 and 2/4 keysREF Level keys MUTE/UNMUTE Solo keys for the channels R LS- SUB RS Installation on Mac Installation on PCIDP Soft Minimum requirements REF LEV. keys Volume ControlMonitor and Sub icons Bass Mgt Bass Management Recall presets IDP Soft Preset ListStore presets Locked symbol in Preset List Upload Software to Monitors IDP Soft Network Analog Gain System Setup ConfigurationBNC Sync Calibrate Main Monitors Monitor Assignment Calibrate Subwoofer LFE Gain Range 0 to 14dB Phase RangeLFE Low Pass Filter Chained monitors System Master & Slaves Technical Specifications Precision 6 iDP Technical Specifications- Precision 8 iDP TS112 iDP Subwoofer & iDP Technical Specifications TS212 iDP Subwoofer Dimensions Precision 6 iDP Dimensions Precision 8 iDP Dimensions Precision TS112 iDP Grey Dimensions Precision TS212 iDP Grey/Silver IDP Display Messages Curves Explained System Delays Sample Rate Digital Input Analog Input SUB LFE TC Link Standard Cat-5 cables CablesAES/EBU Standard cables Serial to Cat-5 cable Declaration Of Conformity Warranty Page Issue Software Version 1.53 Part No GH 01 December