Phase Range, LFE Low Pass Filter | Tannoy ACTIVE STUDIO MONITORS

iDP SOFT™ (cont.)

Phase

Range: 0-180°

To time-compensate if the Sub cannot be placed according to the ITU 775 recommendations. There are individual Phase settings for each of the Bass Management Cross-over frequencies. Once set, these are stored as Global settings.

Polarity

Range: 0 or 180 deg.

Mark to activate.

Calibrated Level

Level calibration of the selected monitor.

Relative Level

Preset volume for the selected monitor relative to the calibrated and global volume.

LFE Gain Range: 0 to 14dB

With this parameter you can boost the gain of the LFE channel.

LFE Low Pass Filter

Mark to activate.

Mute

Press to mute the selected monitor.

Solo

Press to solo the selected monitor.

Pink Noise

Press to generate Pink Noise in the selected monitor.

41

Image 41

Tannoy ACTIVE STUDIO MONITORS owner manual Phase Range, LFE Gain Range 0 to 14dB, LFE Low Pass Filter

Contents

Owners M a N U a L Page Important Safety Instructions Important Safety Instructions Quick Setup Guide T I V E S T U D I O M O N I T O R S Introduction Tannoy Dual Concentric Concept & Design Philosophy Tannoy WideBand SuperTweeter High efficiency compact Switched Mode Power Supply SmpsUnpacking & Visual Checks Orientation Speaker PlacementPreliminary Recommendation Master & Slave Concept Slave Monitor & Subwoofer Remote ControlInitializing the Network IDP Soft Software Remote Slave/Subwoofer Master Unit SUB IDP Display Master General Setup Procedure Analog Stereo Set-up With Mono Subs SetupsGeneral Setup Procedure Stereo Digital Set-up With Mono Subs Analog Stereo Set-up With Stereo Subs Digital Set-up Analog Set-up Digital 192kHz Set-up Digital Set-up Analog Set-up Analog, Digital& 192kHz Alternative 7.1 Set-up Connecting Three Subs Connecting Two Subs Stereo Set-up With Chains on L&R. Analog or Digital Dig/6 Master Setup when the monitors are connected Reset All Settings Reset ProcedureSelect Setup Select Monitor Tasks Parameter Description Press Enter to access the Select ModeMain Display † PC-iP Bass Management PhaseLFE Low Pass Filter LFE Gain Setup Setup MenuSet Monitor Task External Clock LFE channel important Parameters available for the subwoofer Parameter Categories IDP Remote Volume potentiometer Preset 1/3 and 2/4 keysREF Level keys MUTE/UNMUTE Solo keys for the channels R LS- SUB RS Installation on Mac Installation on PCIDP Soft Minimum requirements REF LEV. keys Volume ControlMonitor and Sub icons Bass Mgt Bass Management Recall presets IDP Soft Preset ListStore presets Locked symbol in Preset List Upload Software to Monitors IDP Soft Network BNC Sync System Setup ConfigurationAnalog Gain Calibrate Main Monitors Monitor Assignment Calibrate Subwoofer LFE Low Pass Filter Phase RangeLFE Gain Range 0 to 14dB Chained monitors System Master & Slaves Technical Specifications Precision 6 iDP Technical Specifications- Precision 8 iDP TS112 iDP Subwoofer & iDP Technical Specifications TS212 iDP Subwoofer Dimensions Precision 6 iDP Dimensions Precision 8 iDP Dimensions Precision TS112 iDP Grey Dimensions Precision TS212 iDP Grey/Silver IDP Display Messages Curves Explained System Delays Sample Rate Digital Input Analog Input SUB LFE TC Link Standard Cat-5 cables CablesAES/EBU Standard cables Serial to Cat-5 cable Declaration Of Conformity Warranty Page Issue Software Version 1.53 Part No GH 01 December