using the thermostat control.
-Unplug the appliance from the mains. -Put the cable back in the cable housing.
-The cable housing means you can remove and have available the required length of cable for working with the appliance, preventing accident risk situations.
-Place the frying basket inside the container. The basket handle can be left attached or can be turned toward the inside of the basket by pressing sidewise on the rods and rotating (Fig. 7)
-Close the lid.
Practical recommendations:
-Fry a few pieces of bread to remove the smell of used oil.
-For food with a high water content, it is better and quicker to fry in two lots with less food than in just one. This will reduce the risk of splashes and spillage.
-The “two-stage frying method” can be used for an even and crispy coating. This system consists of first frying the food until it is reasonably well done and then frying again using very hot oil to brown the food.
-Olive oil with a minimum acidity level is recommendable for frying.
-Do not mix different oils.
-Wash potatoes before frying to stop them from sticking
Safety thermal protector:
-In the event of overheating, the thermal safety mechanism will be activated and the appliance will stop operating. When this occurs the appliance should be disconnected from the mains and left to cool. Then press the rearming button, situated at
the back of the electrical circuit, with the tip of a pen or similar in order to reactivate the appliance (Fig. 2).
Cleaning
-Disconnect the appliance from the mains and allow it to cool before undertaking any cleaning task. -Disassemble the appliance in accordance with the following steps:
•Take off the lid
•Remove the basket and take out the electrical equipment
•Remove the bowl
•Carefully pour the used oil from the bowl into a container (not the sink), according to the regulations in force for the treatment and disposal of waste.
-Pour soapy water into the tank to degrease it.
-Except for the power unit and the mains connection, all the parts can be cleaned with detergent and water or in washing up liquid. Rinse thoroughly to remove all traces of detergent.
-Clean the electrical equipment and the mains connection with a damp cloth and dry. DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID. -Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry.
-Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.
-If the appliance is not in good condition of cleanliness, its surface may degrade and inexorably affect the duration of the appliance’s useful life and could become unsafe to use. -The following pieces may be washed in a dishwasher:
•Basket
