27
Model PH90 Operating Procedures
Insert the spinner blade shaft f rom the bottom, into the
center of the driven spinner, and up through t he draw
valve cavity until the shaft appears at t he top of the
draw valve. The spinner blade must be aligned and
engaged to the driven spinner at the bottom. This
allows the spinner shaft to raise high enough to be
engaged into the spinner coupling at the top. (See
Figure 17.)
Figure 17
Raise the locking collar of the spinner coupling and
insert the spinner shaft into the cavity of the coupling
untilt he locking collar can drop into the locked position.
(See Figure 18.)
Figure 18
Step 8
Snap the restrictor cap over the end of t he door spout.
(See Figure 19.)
Figure 19
Freezing Cylinder Assembly --Soft Serve Side
MAKE SURE POWER SWITCH IS IN THE
“OFF” POSITION. Failure to do so may causeinjury
from hazardous moving parts, or electrocution.
With the parts tray available for the soft serve side:
Step 1
Before installing the drive shaft, lubricate the gr oove
on the drive shaft. Slide the drive shaft s eal over the
small end of the shaft and engage into the groove on
the shaft. Heavily lubricate the inside portion of the
seal and also lubricate the flat end of the seal that
comes in contact with the rear shell bearing. Apply an
even coat of lubricant to the shaft. DO NOT lubricate
the hex end. (See Figure 20.)
Note: When lubricating parts, use an approved f ood
grade lubricant (example: Taylor Lube Hi
Performance).
Figure 20