46 Model PH90Operating Procedures
080221
Step 4
When ready to resume normal operation, press the
AUTO keypad. (See Figure 81.)
Note: This procedure should be done 3--4 hours
before the first shake is served, to build up ice crystals.
Figure 81
Soft Serve Side
Step 1
Preparea s mall amount of an approved 100 PPM sani-
tizing solution (examples: Kay--5Ror Stera--
SheenR). USE WARM WATER AND FOLLOW THE
MANUFACTURER’SSPECIFICATIONS. Sanitize the
design cap in this solution.
Step 2
Return to the freezer with a small amount of sanitizing
solution. Dip the door spout brush into the sanitiz ing
solution and brush clean the door spout, and bottom of
the draw valve. (See Figure 82.)
Note: To assure sanitary conditions are maintained,
brush clean each item for a total of 60 seconds,
repeatedly dipping the brush in sanitizing solution.
Figure 82
Install the design cap on the freezer door spout. (See
Figure 83.) Rinse a single service towel in sanitiz ing
solution, and wipe down the freezer door and area
around the bottom of the freezer door. Replace the
front drip tray and splash shield.
Figure 83