RECALL

The Recall Displays

The Recall displays are the "homepage" of the M3000. Whenever you exit any other display this is where you return to.

As illustrated below the Recall display holds a few of the most important parameters for each of the two Engines at the same time. Engine 1 is always displayed in the upper section and Engine 2 in the lower.

The "Edited flag" shows an E when you have changed a parameter in the preset. (See ill.)

Recall Display

Algorithm type Primary parameter Edited flag

Preset number

Engine 1

Engine 2

Primary parameters

Combined Recall Display

Bank indicator (RAM/ROM/CARD)

Preset name

Routing mode

Recalling a Preset

Press the RECALL key on Engine 1 or 2 and scroll through the presets using the ADJUST wheel. Press OK to recall when you find the desired preset. You are able to search for another preset before recalling it. This is called previewing.

Until you press OK you are previewing. At this point your

OK key is blinking, indicating that the preset displayed is not yet recalled (active).

Use the CURSOR keys (or the other RECALL key) to access the other Engine.

You can also use the Wizard to recall presets. (See "The Wizard" on page 14).

If you wish to return to the original preset after editing various parameters without storing your changes, simply press the RECALL key on the appropriate Engine followed by OK.

10

Page 12
Image 12
TC electronic SDN BHD M3000 user manual Recall Displays, Recalling a Preset