REV-3
Rev-3 :
Reverb 3 is a well known TC algorithm from the M5000, and is very good at medium decay times.
Try e.g. presets 77, 81, 83 and 84 to experience the
Pre Delay
The time to arrival of the first reflection.
Decay
Sets the Decay time. The value indicates the time to where the Reverb tail is damped to
Distance
The relative distance control varies the mix relations between early and later reflections. Simulating how far away you are from the sound source.
Mix
Mix between direct and effect.
Out Level
Adjusts Output level. Use this parameter to match levels between presets.
Diffuser type
The natural room mode peak frequencies and the smoothness of the tail are affected by this parameter.
Diffuse
This parameter sets the degree of wall diffusion. Increasing the value will result in a more dense Reverberation tail.
Do not set the value too high, as it will result in an unnatural sounding Reverberation tail.
Hi Cut freq.
Sets the
Hi Damp
(0.01 - 2.5) Multiplier for the frequencies above the Hi Crossover frequency. Example: If the main Decay parameter is set to 2.0sec. and the Hi Decay parameter is set to 1.5, frequencies above the Hi Xover will decay for 3.0sec. Conversely if this parameter is set to 0.5 the Decay time above the Hi Xover point will be 1sec.
Hi Decay
Adjusts the high frequency Reverberation time.
Hi Crossover
Crossover frequency between mid and high band Reverberation filter.
Mid Crossover
Crossover frequency between
Lo Mid Decay
Adjusts the mid frequency Reverberation time.
Lo Crossover
Crossover frequency between low and
Lo Decay
Adjusts the low frequency Reverberation time.
Modulation
Rate
The Mod Rate varies the Rate of modulation of the recirculating delay paths simulating the Reverb tail.
Depth
Controls the amount of Delay Path Modulation or “wander” in the reverb.
46
