Operating Basics
16 80A03 TekConnectProbe Interface Module Instruction Manual
NOTE. Do not connect any other accessory to the sampling oscilloscope Trigger
Probepower port, or use the disconnected sampling module channel for any
other purpose while using this setup. Doing so may causeconfusion that can
lead to measurementerrors.
CSA8000/TDS8000
Triggerdirect input
80A03
Triggerprescaled
input
Circuitunder test
Triggerprobe
Measurementprobe
Figure9: Setupfor triggering the sam plingoscilloscope using the 80A03 TekCon-
nect Probe Interface Module
The sampling oscilloscope respondsto the CH A probe as though it were
connectedto the vertical sampling channel:
HThe Triggerprobe is serviced and controlled by the sampling oscilloscope
CH B vertical channel controls.
HThe probe scaleis not reflected in any trigger level settings assigned by the
trigger setup menu.
HThe offsetcontrol for the vertical channel adjusts the probe offset (if
equipped).
HThe sampling module offsetcontrol is disabled.