Accpt | Teledyne 3160 specs

4 Operations

7. If SET was pressed in step 1, the menu for setting the time and date will appear. Use the SELEC, UP and DOWN keys to set the time and date, and then press

ACCPT.

8. If ZERO was pressed in step 1, the menu for setting AutoZeroing ON/OFF, time/date of the next zeroing, and time interval for automatic zeroing will appear.

9. Use the SELEC, UP and DOWN keys to make selec- tions, and press ACCPT.

10. If SPAN was pressed in step 1, the menu for setting AutoSpanning ON/OFF, time/date for the next calibra- tion, and interval for automatic calibration will appear.

11. Use the SELEC, UP and DOWN keys to make selec- tions, and press ACCPT.

12. If ALRMS was pressed in step 1, a menu displaying the most recent triggering time and date of each of the alarms will appear. From here, press ESC three times to return to the main menu screen.

4-20	TELEDYNE ANALYTICAL INSTRUMENTS

Image 48

Teledyne 3160 manual Accpt

Contents

Model Copyright 1999 Teledyne Analytical Instruments Iii Table of Contents Maintenance & Troubleshooting Appendix Teledyne Analytical Instruments Features Fixed FeaturesVariable Features Introduction Introduction Introduction Components Options and Model Numbers3160DA Dual fuel cell Introduction Applications Operational Theory Principles of Operation Major Components Operational Theory Micro-Fuel Cell Sensor Sample System Operational Theory Electronics and Signal Processing Model 3160 flow schematic Operational Theory Analog signal output offset Identifier Range Scale Voltage CurrentmA Defaults Programmable Options Installation Unpacking the AnalyzerFront Panel Qty Description Rear Panel Analyzer front and rear panels Installation Gas Line Connections Span GasInstrument Air Compressed Air Fitting Sample Gas Sensor Installation Electrical Connections Voltage Selection 3160 Rear Panel Fuse Changing Removing the Voltage Card Fuse Replacement Installation Checklist 3 RS-232 Serial Digital Port Operations Front Panel Controls Modes of Operation Spinning WheelCell Output Factor Span Factor Operations Changing Passwords For Remote Monitoring and Control Uled Span in Progress Operations Cold Start-Up Operations Calibration Zeroing Operations Operations Calibration Using Span Gas Operations Operations Operations Select Active Sensor Two Cells Only Setup Operations Operations O2 Range Set-Up Accpt Operations Set-Up Alarms Cold Start Operations Operations Logger Set-Up Operations Operations Set-Up Clock Functions Accpt Teledyne Analytical Instruments Operations Operations System Statistics Baud rate Ascii Data Bits 7 or Stop Bits 1 orComm. Std. for 1200B Bell USA/CCITT Operations Operations Maintenance & Troubleshooting Routine MaintenanceSensor Maintenance Scrubber Maintenance Troubleshooting Symptom Cause Correction Maintenance & Troubleshooting Symptom Cause Correction Maintenance & Troubleshooting Specifications Operating Temperature0-50C 32 -122 FAppendix Altitude 1,609 m Relative Humidy Up to 99% Teledyne Analytical Instruments Appendix Recommended Spare Parts List Drawing List Appendix Material Safety Data Sheet Customer Service Extension Environmental HealthDate Prepared 2/12/96 Material or Component S. # Quantity Section IV Fire and Explosion Hazard Data Protective measures during cell replacement Exposure Section Viii Control Measures Product Name ManufacturerAddress Phone Signs/symptoms of exposure Primary route of entryExposure limits Osha PEL Effects of overexposure Ingestion Protective measures Disposal