Teledyne 3160 manual Operations

Operations 4

12. After checking for the modem, pressing ESC returns you to status page seven in step 10.

If INIT was pressed in status page 7 and then SETUP pressed in step 11, pressing ACK will return you to this screen. Press ESC to return to status page seven in step 10.

13. If you have purchased the parallel printer option, status page eight allows for configuration of the port. Press EDIT to change the configuration.

• Mode: ON/OFF

• Interval: 3–32000 seconds

NOTE: The printer report will always be in the same for- mat—O2Level, Range, Active Sensor, Time & Date.

14. After pressing EDIT, a cursor will appear and you will be able to edit the settings.

15. Status page nine shows whether or not the last and next start-ups were WARM or COLD. The next start-up may be changed by pressing the COLD or WARM keys.

16. Status page ten displays logger data. Press VIEW to see the logger data history. Press NEXT to return to status page one. Press ESC twice to return to the Analyze mode main menu.

17. If VIEW was pressed in step 13, logger data may be viewed by using the +, –, REV and FWD keys. The O2 level, range, and time are shown for each data point. NEXT takes you to status page two.

REV and FWD change the date by one page (or 64 points), while – and + go through the data one point at a time within a single page. Press ESC to return to status page ten.

TELEDYNE ANALYTICAL INSTRUMENTS 4-25