Fuse Replacement | Teledyne 3160 specification

Installation 3

WARNING: Power cord must be disconnected before performing any voltage selection!

To change from North American to European fuses, perform the following:

1. Use a small blade screwdriver to open the cover.

2.Loosen the Phillips screw two turns and remove the fuse block by sliding it away from the screw and up from the pedestal.

3.Remove the North American fuse and turn the fuse block over.

4.Replace the fuse with European fuses. Two European fuses are required, but the lower one may be replaced with a dummy fuse, or jumper bar (see Figure 3–6).

European 1.6 Amp T Fuses

5 x 20 mm

North American 3 A T Fuses

Figure 3–6: Fuse Replacement

5.Slide the fuse block back on the Phillips screw and pedestal.

6.Tighten the Phillips screw and replace the cover.

NOTE: The fuses that go into the housing first are the active set.

TELEDYNE ANALYTICAL INSTRUMENTS

3-9

Image 27

Teledyne 3160 manual Fuse Replacement

Contents

Model Copyright 1999 Teledyne Analytical Instruments Iii Table of Contents Appendix Maintenance & Troubleshooting Teledyne Analytical Instruments Introduction FeaturesFixed Features Variable Features Introduction Introduction Components Options and Model Numbers3160DA Dual fuel cell Introduction Applications Principles of Operation Operational Theory Major Components Sample System Operational Theory Micro-Fuel Cell Sensor Operational Theory Model 3160 flow schematic Electronics and Signal Processing Operational Theory Identifier Range Scale Voltage CurrentmA Analog signal output offset Defaults Programmable Options Qty Description InstallationUnpacking the Analyzer Front Panel Rear Panel Analyzer front and rear panels Sample Gas Installation Gas Line ConnectionsSpan Gas Instrument Air Compressed Air Fitting Sensor Installation Electrical Connections 3160 Rear Panel Voltage Selection Removing the Voltage Card Fuse Changing Fuse Replacement 3 RS-232 Serial Digital Port Installation Checklist Front Panel Controls Operations Modes of Operation Spinning WheelCell Output Factor Span Factor Operations Uled Span in Progress Changing Passwords For Remote Monitoring and Control Operations Cold Start-Up Operations Calibration Zeroing Operations Operations Calibration Using Span Gas Operations Operations Operations Select Active Sensor Two Cells Only Setup Operations Accpt Operations O2 Range Set-Up Cold Start Operations Set-Up Alarms Operations Operations Logger Set-Up Operations Operations Set-Up Clock Functions Accpt Teledyne Analytical Instruments Operations Operations System Statistics Baud rate Ascii Data Bits 7 or Stop Bits 1 orComm. Std. for 1200B Bell USA/CCITT Operations Operations Scrubber Maintenance Maintenance & TroubleshootingRoutine Maintenance Sensor Maintenance Symptom Cause Correction Troubleshooting Maintenance & Troubleshooting Symptom Cause Correction Maintenance & Troubleshooting Specifications Operating Temperature0-50C 32 -122 FAppendix Teledyne Analytical Instruments Altitude 1,609 m Relative Humidy Up to 99% Drawing List Appendix Recommended Spare Parts List Material or Component S. # Quantity Appendix Material Safety Data SheetCustomer Service Extension Environmental Health Date Prepared 2/12/96 Section IV Fire and Explosion Hazard Data Exposure Protective measures during cell replacement Section Viii Control Measures Phone Product NameManufacturer Address Effects of overexposure Ingestion Signs/symptoms of exposurePrimary route of entry Exposure limits Osha PEL Disposal Protective measures