Teledyne T703, T703U user manual WARNING

A Primer on lectro-Static Discharge Teledyne API T703/T703U Calibrator Operation Manual
226
10.4.2.5. Packing Components for Return to Teledyne API
Always pack electronic components and assemblies to be sent to Teledyne API in anti-
ESD bins, tubes or bags.
WARNING
 DO NOT use pink-poly bags.
 NEVER allow any standard plastic packaging materials to touch the
electronic component/assembly directly
 This includes, but is not limited to, plastic bubble-pack, Styrofoam
peanuts, open cell foam, closed cell foam, and adhesive tape
 DO NOT use standard adhesive tape as a sealer. Use ONLY anti-ESD tape
1. Never carry the component or assembly without placing it in an anti-ESD bag or bin.
2. Before using the bag or container allow any surface charges on it to dissipate:
 If you are at the instrument rack, hold the bag in one hand while your wrist strap
is connected to a ground point.
 If you are at an anti-ESD workbench, lay the container down on the conductive
work surface.
 In either case wait several seconds.
3. Place the item in the container.
4. Seal the container. If using a bag, fold the end over and fastening it with anti-ESD
tape.
 Folding the open end over isolates the component(s) inside from the effects of
static fields.
 Leaving the bag open or simply stapling it shut without folding it closed prevents
the bag from forming a complete protective envelope around the device.
NOTE
If you do not already have an adequate supply of anti-ESD bags or containers available, Teledyne API’s
Technical Support department will supply them (see Section 8.8 for contact information).
Follow the instructions listed above for working at the instrument rack and workstation.
07223C DCN6572