Teledyne T703, T703U 4.5.1.7. Setting the Progress Reporting Mode for the Sequences

Teledyne API T703/T703U Calibrator Operation Manual Operating the Calibrator
61
4.5.1.7. Setting the Progress Reporting Mode for the Sequences
As sequences run, the calibrator reports progress by displaying a message in the MODE
field of the front panel display (See Figure 3-1). There are several types of report modes
available
Table 4-5: Sequence Progress Reporting Mode
MODE DESCRIPTION
STEP  Shows the progress as the sequence name and step number. This is the traditional display.
Example: “SO2_Test-2”.
PCT  Shows the progress as a percent (0–100%) of the total sequence duration.
Example: “SEQ 48%”
ELAP
 Shows the progress as days, hours, minutes and seconds elapsed, counting up from 0.
Example (<1 day): “T+01:30:25” (i.e. 1 hour, 30 minutes, 25 seconds elapsed)
Example (>=1 day): “T+1d30:25” (i.e. 1 day, 30 hours, 25 minutes elapsed)
REM
 Shows the progress as days, hours, minutes, and seconds remaining, counting down to 0.
Example (<1 day): “T–01:30:25” (i.e. 1 hour, 30 minutes, 25 seconds remaining)
Example (>=1 day): “T–1d30:25” (i.e. 1 day, 30 hours, 25 minutes remaining)
To select a PROGRESS report mode, press:
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ
Make sure that the
calibrator is in standby
mode.
SETUP X.X
O3 CFG CLK PASS MORE EXIT
SETUP X.X
PRINT
SETUP X.X
PRNT EXIT
SETUP X.X
PREV NEXT INS PRNT EXIT
EDIT EXIT
Deletes the sequence shown
in the message field
Edits the sequence shown
in the message field
Scrolls back and forth between
existing sequences Continue pressing SET> until ...
This display only appears if there are no sequences currently
programmed into the calibrator.
OTHERWISE ...
<SET EXIT
STEP PCT REM
Use these buttons to
choose a
8
<SET
07223C DCN6572