Teledyne T703, T703U Appendix C Warranty/Repair Questionnaire T703, T703U, 703E , PARAMETER , VALUE

Appendix C
Warranty/Repair Questionnaire
T703, T703U, 703E
(05747D DCN6572)
Teledyne API Technical Support
Email: sda_techsupport@teledyne.com
PHONE: (858) 657-9800 TOLL FREE: (800) 324-5190 FAX: (858) 657-9816
C-1
CUSTOMER:_______________________________ PHONE: _____________________________________
CONTACT NAME: __________________________ FAX NO. _____________________________________
SITE ADDRESS:____________________________________________________________________________
MODEL TYPE: ______________ SERIAL NO.:_________________ FIRMWARE REVISION:_____________
Are there any failure messages? _______________________________________________________________
_________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
________________________________________________________________________ (Continue on back if necessary)
PLEASE COMPLETE THE FOLLOWING TABLE:
PARAMETER
Name in E-Series software
versions prior to v.C.1 Name in T-Series and in E-Series w/software v. C.1 and higher. RECORDED VALUE ACCEPTABLE
VALUE
ACT ACT PPB 1% OF TARG
TARG TAR PPB 50 – 1000 PPB
OUTPUT FLOW OUT FLW LPM 2 – 5 LPM
REG PRESSURE REG PRES PSIG 15 ± 2 PSIG @ 5 LPM
(n/a) O3 PRES
1, 2 (703U only) PSIG 8 ± 1 PSIG @ 5 LPM
BOX TEMP BOX TMP ºC 20 – 35 ºC
O3 GEN REF 2 O3GEN REF
2 mV 0 – 5000 mV
O3 GEN DRIVE 2 O3GENDRV
2 mV 0 – 5000mV
O3 LAMP TEMP 2 O3LAMPTMP
2 ºC 48 ± 1 ºC
PHOTO MEASURE 3 PH MEAS
3 mV 2500 – 4700 mV
PHOTO REFERENCE 3 PH REF
3 mV 2500 – 4700 mV
PHOTO FLOW 3 PH FLW
3 LPM 0.720 – 0.880 LPM
PHOTO LAMP TEMP 3 PH LTEMP
3 ºC 58 ± 1 ºC
PHOTO SPRESS 3 PH SPRES
3 IN-HG-A -1” AMBIENT IN-HG-A
PHOTO STEMP 3 PH STEMP
3 ºC 25 – 48ºC
PHOTO SLOPE 3 PH SLOPE
3 1 ± 0.15
PHOTO OFFSET 3 PH OFFST
3 PPB 0 ± 10 PPB
(n/a) PH STAB
3 PPB <1 ppb on Zero Air
Depending on options installed, not all test parameters shown will be av ailable in your calibrator.
1 Ozone Regulator Pressure
2 If ozone generator option inst alled.
3 If photometer option installed.
What is measured photometer flow rate ____________________________________________________ cc3/min
07223C DCN6572