Teledyne T703, T703U 3.4.3. WARNING MESSAGES

Getting Started Teledyne API T703/T703U Calibrator Operation Manual
40
3.4.3. WARNING MESSAGES
Because internal temperatures and other conditions may be outside be specified limits
during the calibrator’s warm-up period, the software will suppress most warning
conditions for 30 minutes after power up. If warning messages persist after the 30
minutes warm up period is over, investigate their cause using the troubleshooting
guidelines in Section 8 of this manual.
To view and clear warning messages, press:
Once the last warning has
been cleared, the MESSAGE
FIELD will return to displaying
the currently selected TEST
FUNCTION and value.
Suppresses the
warning messages
Press CLR to clear the current
message.
If more than one warning is
active, the next message will take
its place.
NOTE:
If a warning message persists after
several attempts to clear it, the message
may indicate a real problem and not an
artifact of the warm-up period
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
STANDBY SYSTEM RESET
TEST GEN STBY SEQ MSG CLR SETUP
SYSTEM ANALOG CAL WARNING
TEST CLR SETUP
MSG returns the active
warnings to the message
field.
STANDBY ACT =STANDBY
<TST TST> GEN STBY SEQ SETUP
Table 3-6 lists brief descriptions of the warning messages that may occur during start up.
07223C DCN6572