Telos NX12 user manual Protocol AT&T Point-to-Point Custom

120   Appendix 3

Give us:

♦♦ Two SPID numbers, depending upon number of active B channels ♦♦ Two Directory Numbers

PROTOCOL: AT&T Point-to-Point (Custom)

Software version 5E4.2 and above.

CO Values

♦♦ Line Type (DSL class): Custom Point-to-Point (PTP)

♦♦ B1 Service: On Demand (DMD)

♦♦ B2 Service: On Demand (DMD)

♦♦ Maximum B Channels (MaxChan): 2

♦♦ CSV Channels: Any

♦♦ Number of CSV calls: 2

♦♦ CSD Channels: Any (CSV is required; CSD may be omitted if requested by user)

♦♦ Number of CSD calls: 2

♦♦ Terminal Type: A

♦♦ Number Display: No

♦♦ Call Appearance Pref:Idle

♦♦ 10XXXXX Long Distance Prefix: Yes

Turn off features such as; packet mode data, multiple call appearances, Electronic Key Tele- phone Sets (EKTS), shared directory numbers, accept special type of number, intercom groups, network resource selector (modem pools), message waiting, hunting, interLata competition, etc.

Note for AT&T/Lucent 5ESS on loop extended lines: REX test must be disabled for this line

using one of the following: ASDFI266 (Prohibit REX on BRI lines per office) or ASDFI267 (Prohibit REX on BRI lines per line)

Give us:

♦♦ One Directory Number