Tiger JD 5093E, JD 5083E, JD 5101E manual Assembly, Tractor Preparation, Crankshaft Adapter

ASSEMBLY

Before attempting to mount or service your Tiger mower, it is important to read and understand all of the information in the Safety section of this manual.

Check complete shipment list against the packing list to make sure there are no shortages. Make certain the tractor model is the appropriate one for the mower received!

Use a floor jack, hoist or fork lift to lift or raise heavy parts whenever possible whether mentioned or not.

Read and understand the entire assembly section instructions before attempting to mount your Tiger mower. Refer to the parts section of this manual for detailed illustrations to locate all parts.

TRACTOR PREPARATION

A:Remove right hand steps.

B:Disconnect cables from both batteries, (remove batteries and the battery box from cab units only.)

C:Remove engine side panels, or raise hood to access front pulley.

D:Remove plugs from tractor casting where main frame and pump mount will be attached.

E:Raise the tractor onto jack-stands and remove the right rear wheels.

CRANKSHAFT ADAPTER

If necessary remove the four cap-screws from the crankshaft pulley and keep them to reuse. Remove the large washer and discard. Then install the crankshaft adapter and spacer to the pulley with cap-screws and lock-washers as shown in the parts section.

Assembly Section 2-2

12-6-01