TOA Electronics 12. SELECTING OPERATION METHOD

12. SELECTING OPERATION METHOD

In the matrix mode, when the unit's power is first turned on after shipment from the factory, there is the case where the operation method can be or cannot be selected. This depends on the 9000 Series amplifier model and its module configuration. When the operation method selection is possible, proceed to the related settings after selection.

POWER

When AC power is first fed to the unit and the power switch is first turned on after the unit was shipped from the factory.

Memory check

When the A-9060S, A-9120S, or A-		Unless otherwise specified:	When the A-9060DH or A-9120DH with ZP-
924SH without T-001T installed is		The unit operates in the normal	001T but without T-001T installed is used:
used:		matrix operation.	Either the 2-channel output operation or
Either the 1-channel output operation		Any other operation methods	normal matrix operation can be selected.
or normal matrix operation can be		cannot be selected.	Note
selected.			As the 2-channel operation method applies
			to only the amplifier with high-impedance
			output, press the Escape/Back key at the
			operation method selection screen as
			shown below when the amplifier model is A-
			9120DL (low-impedance output version).
Operation method selection screen			Operation method selection screen
S I N G L E - O U T A P P L I ?			B G M / P A G E A P P L I ?
ENTER	ESC/BACK		ESC/BACK	ENTER

M O D E S I N G L E - O U T M O D E M A T R I XM O D E B G M / P A G E

1-channel output operation	Normal matrix operation	2-channel output operation
		(BGM/Paging operation)

Note

Once the operation method is set, its selection screen does not appear until the settings are initialized. To change the operation method, change the relevant setting in the Utility setting flow. (Refer to p.54.)

35