TOA Electronics manual 53

From the previous page

(P. 55-C1)

Function selection

(when the remote volume control is selected)

U T I L I T Y R E M O T E

PARAMETER

Remote controller type setting	PARAMETER		PARAMETER
		(when the remote controller type		(when the remote controller type
(when the remote controller type
is set to VOLUME) (p. 61-C26)		is set to ZM-9001) (p. 61-C26)		is set to ZM-9002) (p. 61-C26)
R E M O T E 1 V O L U M E		R E M O T E 1 Z M - 9 0 0 1		R E M O T E 1 Z M - 9 0 0 2

or

Function selection		ANC monitor switching ON/OFF
(when the ANC monitor is selected)		setting (p. 62-C29)
U T I L I T Y	A N C	A N C M O N S E L E C T = O N

PARAMETER

or

	(In the normal matrix operation)
Function selection
(when the Event activation at		Setting the Event to be recalled
power-on is selected) (p. 55-C1)		when power is switched on (p. 63-C34)
U T I L I T Y	E V E N T	P O W E R O N – E V E N T L A S T

Remote-controlled channel setting* (p. 61-C27)

R E M O T E 1 O U T P U T 1 * In the 1-channel output operation,

the selectable output channel is Output 1 only.

(When the remote-controlled channel is the output channel) Volume-controlled signal setting (p. 61-C28)

V A L I D F O R A L L

(When the ANC monitor switching is set to ON)

Monitor switching control input terminal setting (p. 62-C30)

M O N S E L E C T C I N 0 1

Interlock output control setting (p. 62-C31)

M O N S E L S Y N C O N

(When the interlock output control is set to ON)

Monitored ANC input channel selection (p. 62-C32)

S E L E C T S Y N C A N C 1

Interlock output terminal setting (p. 62-C33)

S E L E C T S Y N C C O U T 0 1

(In the 1-channel or 2-channel output operation)

Function selection
(when the input channel activation		Setting the input channel to be recalled
at power-on is selected) (p. 55-C1)		when power is switched on (p. 63-C35)
U T I L I T Y	C H A N N E L	P O W E R O N – C H L A S T

PARAMETER
	or
To the next page	53