[When the function is set to EVENT:] (Only in the normal matrix operation) (C34) Setting the Event to be recalled when power is switched on

P O W E R O N – E V E N T L A S T

Setting Range LAST (default), 01 – 32 (only for Events set for ROUTE or BASE)

Set the Event number to be activated when the unit's power is switched on.

Since no trigger is provided for Event activation at power-on, select the Event number that corresponds to either the BGM Event or the BASE Event (with [ ] mark suffixed to its Event number), both set in the ROUTE Event setting.

When LAST is selected, the unit returns to the state before power-off when turned on.

The unit operation depends on the trigger condition at power-on when there was an Event (interrupt broadcast) or function (mute or emergency mute) being activated by a level trigger before power-off.

[When the function is set to CHANNEL:] (Only in the 1-channel or 2-channel output operation) (C35) Setting the input channel to be recalled when power is switched on

P O W E R O N – C H L A S T

Setting Range LAST (default), IN1 – 8

Set the input channel that is recalled at power-on.

Since no trigger is provided for input channel activation at power-on, select one from input signals (BGM) with Priority 8 (with an asterisk suffixed to the channel number).

When LAST is selected, the unit returns to the state before power-off when turned on.

The unit operation depends on the trigger condition at power-on when there was an interrupt broadcast or function (mute or emergency mute) being activated by a level trigger before power-off.

[When the function is set to SUB-MODE:]

(C36) Operation method setting

M O D E M A T R I X

Set the operation method.

Only the methods that meet the operation requirements can be selected.

Setting Range MATRIX, SINGLE-OUT, BGM/PAGE

Each operation method can be selected when the following requirements are satisfied:

The 1-channel output operation (SINGLE-OUT) or normal matrix operation (MATRIX) can be selected when the A-9060S, A-9120S, or A-9240SH without T-001T installed is used.

The 2-channel output operation (BGM/PAGE) or normal matrix operation (MATRIX) can be selected when the A-9060DH or A-9120DH with ZP-001T but without T-001T installed is used.

On the conditions except above, the operation method cannot be selected but is fixed to the normal matrix operation .

Changing the operation method here and confirming it with the Memory key initialize the settings that contradict the reset operation method.

63