Toshiba 3511 manual ADD Paper Symbol, 248, Adding Paper to the Drawers

2. ADD PAPER SYMBOL

Adding Paper to the Drawers

When the paper in the selected drawer or the large capacity feeder (optional) runs out, the drawer or large capacity feeder on the screen blinks, and “Add paper” appears. Add paper as the following procedure.

1 Pull out the drawer carefully until it comes to a stop.

2 Place paper in the drawer(s).

- Place paper face up.

- Maximum number of sheets that can be set. "Acceptable Copy Paper Types and Sizes" Page 38

- Fan the paper well before placing it in the drawer.

- Do not add paper above the line indicated on the guide.

- Do not use creased, folded, wrinkled or damp sheets of paper.

Make sure that a gap of approx. 0.02” (less than 0.04” in total) is left between the paper and the side guide. If there is no gap, this could cause paper misfeeding.

3 Push the drawer straight into the equipment until it comes to a stop.

- Be sure to push the drawer carefully and fully in.

12 - This procedure can be used to add paper to any of the drawers in the paper feed pedestal (optional) as well.

0.5mm

(0.02’’)

Be careful not to let your fingers be caught when closing the drawer. This could injure you.

248 12.WHEN THE GRAPHIC SYMBOLS BLINK ON THE TOUCH