Toshiba e-studio 550/650/810 manual Reduction and Enlargement Copying, Press the AMS key

Page2-4

2. REDUCTION AND ENLARGEMENT COPYING

	When placing originals on the glass, you can copy them at the reducing and enlarging rate of 25 to 400%.
	For the reversing automatic document feeder, you can make copy at the reducing and enlarging rate of 25
	to 200%.
	There are the following three ways of making copies in the reduction and enlargement mode:
		Using Automatic Magnification Selection (AMS)
		Specifying both original size and copy size
		Using the reduction/enlargement zoom keys or the one-touch zoom keys
	*	It is not possible for the device to perform Automatic Magnification Selection with highly transparent
3		originals such as OHP films and tracing paper, wholly dark originals or originals with dark borders, or
		irregular sized originals such as newspapers and magazines. For these types of originals, use the other
		reduction/enlargement modes.
		Original sizes for which Automatic Magnification Selection (automatic detection) is available	Page 2-9
	* Set the paper size for “the OTHER” key as required ( Page 5-14). When the set originals or paper are
		a non-standard size other than A3, A4, B4 or B5, you will select the OTHER key on the screen of step
		3 below. Before pressing it, you need to make the OTHER key recognize the same size as the originals
		or paper that have been set.

Automatic Magnification Selection (AMS)

1 Place paper in the drawer(s).

2 Press the desired drawer, then the ZOOM··· key.

-The copy paper size is selectable on the screen in step 3 as well.

3

4

Press the AMS key.

- OTHER key Page 5-14

Place the original(s). Page 2-9

-The built-in sensors automatically detect the size of the original(s) and compute the reproduction ratio using the specified paper size.

-If the following messages are shown, proceed as directed:

Change direction of original

Use reduced-size drawer

Select other copy modes as required.

5 Press the START key.

3-4 SETTING OF BASIC COPY MODES