1
2
3
4
5
6
7
8
9
10
11
12
2-3
- After starting copying, press the JOB STATUS key on the control panel, then press the
STATUS ke y on the touch panel to indicate which drawer is in use. When paper runs out of
each drawer, the empty drawer will flash.
To make multiple sets of copies:
- Key in the copy quantity .
- To correct the input copy quantity , press the CLEAR ke y.
When the paper has run out in the middine of copying:
JOB STATUS key flashes. Press this ke y to check which drawer
is flashing and add papers.
To stop a copy operation Page 2-15
When this message appears “Wait”:
The copier may automatically go into the adjustment mode. It
will soon start working. Do not turn OFF the power. Just wait
for a while.
6Once the final original has been scanned, press the FINISHED key.
- When the reversing automatic document feeder is used, and the single-feed mode is selected, the
procedure is slightly different from the above. Procedure of using the single-feed mode Page 5-3
When Coming Across the Situations below
The paper exits with its printed side down except in the following
cases.
When paper is exited with its printed side up:
- When ‘Non-sort / Non-staple’ mode is selected for setting the
original on the original glass.
- When the paper size is not set for bypass copying.
Exiting Copy Papers