3. PROGRAMMING OPERATIONS EO1-11138
3-1
3.1 Programming Operations Common with Standalone ECR Level
3. PROGRAMMING OPERATIONS
The system should be programmed fully by your local TOSHIBA TEC representative at the time of delivery
according to the user’s requirements so that daily operations can immediately start. However, some data must be
added or changed daily or in a longer period. Since the volume of programming contents for the system is too
large, this chapter and the following two chapters are provided as guide lines of the user’s daily programming and
maintenance operations. If there are any unclear points or program data other than listed here must be changed
or added, please contact your TOSHIBA TEC representative. Please also note that some programming
operations introduced in the Standalone Level are modified or not available on in-line terminals.

3.1 Programming Operations Common with Standalone ECR Level

The following is the table of programming operations which are introduced in the Manager’s Guide for the
Standalone Level and can be operated on in-line terminals as well, with the Submode No. and operation
sequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal only and
down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL is
further necessary to load the new data (after the change) to all the Satellite Terminals (to be described in the next
chapter).
PROGRAMMING JOB LIST
Master: Programming is possible on the master terminal while the RTR declaration is ON.
Satellite: Programming is possible on the master terminal (while the RTR declaration is OFF), the backup master
terminal and the satellite terminals.
O: Available
Submode Programming Job Terminal
No. Master Satellite
1 Store Name/Message, Commercial Message, Footer Logo Message O O
Programming
2 Cashier Programming O
3 Department Table Programming O
4 PLU Table Programming O
5 Time Setting or Adjustment O O
6 Date Setting or Adjustment O O
7 Hourly Range Setting O
8 Amount Limit Setting for Function Keys and Guests O O
12 Non-taxable Limit Amount and Gratuity Rate Setting O
13 Minor Group Name Programming O
14 Major Group Name Programming O
15 Customer File Table Setting O
19 Combination Report Table Programming O O
24 PLU Stock Loading or Changing O O
26 Tare Table and Scale Unit Weight Programming O
27 PLU Preset-code Key and Display Key Setting O O
WARNING!

Never try to access a program item other than those in the following list. If you access it and

mistakenly change important data, a malfunction may occur on your completed system.