Toshiba HDD-J35 manual Manual Setup, Reset Data

MANUAL SETUP

1. On the “INSTALLATION” page, highlight “MANUAL SETUP” and press the “ENTER” button.

2. Select channel number. Be sure you know the channel number and its RF frequency. You may refer to Digital TV and Radio channel table in Appendix 1.

3. Press “￿” button to highlight “Frequency”, “Bandwidth” and “Priority” to make sure the parameters are correct, then press “￿” button to highlight “Start Scan” and press the “ENTER” button to start scanning.

•If scanning is successful, “Start Scan” will change to “Get Channel Success” and signal quality will be shown. At this point you can press “EXIT” to leave “MANUAL SETUP” or continue scanning other channels.

•If scanning is unsuccessful, “Start Scan” will change to “Timeout Error”. At this point you can rescan

the signal or refer to the SIGNAL LEVEL bar and signal QUALITY for aligning the direction of the antenna to get the signal. Refer to your antenna installer if problem persists.

Notes:

1.For Australia, the BANDWIDTH should be 7MHz.

2.The PRIORITY should be set to “HIGH” for Australia.

3.SIGNAL LEVEL refers to the input RF signal strength as perceived by the recorder. Note that too strong a signal may cause erroneous readings. If you use an antenna booster and find that you still get a low signal level, your booster gain may be set too high. In this case, adjust the gain accordingly. You may also see the OSD “Bad or No Signal” or “Weak Signal” when the signal level is low.

QUALITY refers to the quality of the received digital signal. A high value of quality means that there are few errors in the signal. In the same way, a low value of quality implies that there are a large number of errors in the signal, which may cause distortions in video and audio.

SNR is the signal-to-noise ratio. A high SNR value means that you have a reasonably good reception (good signal level and good quality).

RECEIVING

RESET DATA

Use this function when you want to clear channel data and reset the password to default (“0000”).

This function is to be used under any one of the following circumstances:

−When the “Region Selection” menu does not appear on step 6 of page 27;

−When moving to another city.

1.On the “INSTALLATION” page, highlight “RESET DATA” and press the “ENTER” button.

2.Select “YES” to restore to default data.

3.The recorder will reboot automatically. You will see a message “Database Empty” after the boot up process. You can then proceed to set up your recorder by following the instructions on page 27.

35