Toshiba MMY-MAP1604HT8-E, MMY-MAP1604HT8ZG-E, MMY-MAP1004HT8ZG-E <Corrective trial>

SMMS-i Installation Manual

<Corrective trial>

▼Start operation

1 Set the rotary switches on the interface P.C. board of the header outdoor unit as below. When in “COOL” mode: SW01=[2], SW02=[5], SW03=[1].

When in “HEAT” mode: SW01=[2], SW02=[6], SW03=[1].

7-segment display

[A]			[B]
[C	]	[	]
[H	]	[	]

2 Push and hold SW04 for more than 2 seconds.

NOTE

•You cannot change the temperature setting during the test run.

•Errors are detected as usual.

•The unit does not perform test run for 3 minutes after turning the power on or stopping running.

7-segment display

[A]			[B]
[C	]	[	-	C	]
[H	]	[	-	H	]

▼Stop operation

1 Set the rotary switches on the interface P.C. board of the header unit back: SW01 to [1], SW02 to [1] and SW03 to [1].

7-segment display

[A]		[B]
[U1]	[	]

SMMS-i

Interface PC board

Installation Manual

SW04 SW05 SW15

Push switch Push switch

D600 D601 D602 D603 D604

7-segment				7-segment
display [A]				display [B]
	SW01	SW02	SW03

Rotary switches

EN

59-EN – 30 – 60-EN