Toshiba RAS-13UKV-E2, RAS-13UAV-E2 service manual Automatic operation, Time

							FILE NO. SVM-03008
2)	Defrost operation	8-2-4. Automatic operation
	Operation of the compressor is stopped once,	(1) As shown in Fig. 8-2-9, the operation mode
	turn off power coupler for 4-way valves after
			(COOL, DRY, HEAT) is selected according to the
	10 seconds, and then exchange the 4-way
			outside temperature and room temperature when
	valves.
			the operation has started.
	After 20 seconds, restart operation of the
			The operation in Fan mode continues until an
	compressor. Turn off the outdoor fan just when
			operation mode is selected.
	the compressor stopped.
			If the room temperature is 20° C or higher when
	If temperature of the indoor heat exchanger
			“AUTO” operation started within 2 hours after
	lowered than 38° C, stop the indoor fan.
			“HEAT” operation had stopped, select an operation
3)	Defrost reset
			mode after Fan operation of ultra low fan.
	Resetting operation from defrost to heating is		In AUTO operation, the set temperature of each
	performed when anyone of the following		operation can be corrected by the remote
	conditions is satisfied.		controller in the range of 17 to 30° C.
	a. Temperature of the outdoor heat exchanger	(2) After selecting the operation mode (COOL, DRY,
	rose to +8° C or higher.
			HEAT), select an operation mode again when a
	b. A status that temperature of the outdoor
			status that the compressor was turned off by the
	heat exchanger is +5° C or higher continued
			room temperature or outside air temperature
	for 80 seconds.
			continues for 15 minutes.
	c. Defrost operation continued for 15 minutes.
		(3) Powerful Cool mode control
In resetting defrost operation, the compressor
			When the outside temperature is above 32° C and
stops for 50 seconds if defrost has started under
			indoor temperature is above 28° C, select Cool
condition a. to c. in item1), but the compressor is
			mode control. In Cool mode, the air flow louver
reset to heating operation keeping operated if
			directs downward. When the room temperature
defrost has started under condition d. in item 1).
			gains access to the set temperature, it becomes
(5) Louver control
			cool memory position.
When the compressor is turned off by high-temp.
release control, the vertical air flow louvers close		TA								Powerful Cooling/Drying with
once and then return to the position of previous										setting on remote controller
		28								Ts = 25° C
time.		26								Cooling/Drying with setting
										on remote controller
		24								Ts = 25° C
		23								Monitoring
			Heating with setting							(Follow to the Fan control in
			on remote controller							previous mode when being
		20	Ts = 25° C							selected again.)
	Ts correction by
			5	15 18			24		32		To
	outside temperature		− 2			− 1		0		+1
	( To)				Fig. 8-2-9

– 30 –