FILE NO. SVM-03008
– 73 –1) Remove the front panel, electrical part and the
horizontal louver with the procedure 3.
2) Remove the pipe holder on the rear side of the
main unit.
3) Remove 2 screws of the heat exchanger on the
base bearing side.
4) Remove 2 screws of the heat exchanger on the
left side (upper and lower) from the back body,
and then pull out the upper side of the heat
exchanger slowly.
1) Remove the front panel and the electrical part
with the procedure 2.
2) Loosen the set screw of the cross flow fan.
3) Remove 2 screws fixing the motor band (R).
4) Pull out the fan motor.
4Heat exchanger
5Fan motor
2 Pipe holder
3 2-Screws
4 2-Screws
No. Part name Procedures Remarks
Reference
line
Pull out the lead
wires of the fan motor
from this hole.
Reference line
When mouting the fan motor,
put the R end of the connector
cover this reference line.
Connector cover
Mounting the fan motor as shown in
figure below.