Toshiba RAS-13UKV-E2, RAS-13UAV-E2 service manual Set take-out part of the lead wire of coil to

				FILE NO. SVM-03008
No.	Part name		Procedures	Remarks
9	Pulse modulating	1. Detachment
	valve coil	1)	Perform work of item 1 of 1, and 2,	3, 5.
		2)	Turn the coil clockwise (counterclockwise) by
			90 degrees, and remove coil from the pulse
			modulating valve.

2. Attachment		Take-out part
		of lead wire
1) Set take-out part of the lead wire of coil to the		Notch
coil inserting position of the pulse modulating
			Coil fix
valve, and attach the coil.		Coil inserting	position
2) Turn the coil by 90 degrees, set surely the		position
concave part at lower part of the coil to the
positioning hole of the pulse modulating valve,
and then fix the coil.
	The pulse modulating valve has A room	Coil inserting	Positioning
	side and B room side. After mounting it,
		position	hole
	check that coil at B room side (Red
	marking is marked on the pulse modulat-
	ing valve.) is connected to CN13 of the
	control board assembly.

!	Fan guard	1. Detachment
		1)	Perform work of item 1 of 1, and 2.
		2)	Remove the front cabinet, and put it down so
			that fan guard side directs downward.
				Perform work on a corrugated cardboard,
				cloth, etc. to prevent flaw to the product.
		3)	Remove the hooking claws by pushing minus		Minus screwdriver
			screwdriver according to the arrow mark in the
			right figure, and remove the fan guard.		Hooking claw

2. Attachment

1)Insert claw of the fan guard in the hole of the front cabinet. Push the hooking claws

(10 positions) by hands and fix the claws.

All the attaching works have completed. Check that all the hooking claws are fixed to the specified positions.

– 80 –