Toshiba RAV-SP180UT-UL Wireless remote control, Procedure, Cooling test run, Heating test run

4-way Air Discharge Cassette Type Installation Manual

Wireless remote control

Procedure 1

Turn on the power of the air conditioner. When power is turned on for the first time after installation, it takes approx. 5 minutes until the remote control becomes available. In the case of subsequent power-on, it takes approx. 1 minute until the remote control becomes available. Execute a test run after the predetermined time has passed.

Procedure 2

Push “ON/OFF” button on the remote control, select [COOL] or [HEAT] with “MODE” button, and then select [HIGH] with “FAN” button.

Procedure 3

Cooling test run	Heating test run
Set the temperature to 64 °F	Set the temperature to 86 °F
(18°C) with the temp. setup	(30°C) with the temp. setup
buttons.	buttons.

Procedure 4

Cooling test run	Heating test run
After confirming a signal	After confirming a signal
receiving sound “beep”	receiving sound “beep”
immediately set the	immediately set the
temperature to 66 °F (19°C)	temperature to 84 °F (29°C)
with the temp. setup buttons.	with the temp. setup buttons.

Procedure 5

Cooling test run	Heating test run
After confirming a signal	After confirming a signal
receiving sound “beep”	receiving sound “beep”
immediately set the	immediately set the
temperature to 64 °F (18°C)	temperature to 86 °F (30°C)
with the temp. setup buttons.	with the temp. setup buttons.

Procedure 6

Repeat procedures 4 → 5 → 4 → 5.

Indicators “Operation” (green), “Timer” (green), and “Ready” (orange) in the wireless receiver section flash in approx. 10 seconds, and the air conditioner starts operation. If any of these indicators does not flash, repeat procedures 2 to 5.

Procedure 7

Upon completion of the test run, push “ON/OFF” button to stop operation.

<Overview of test run operations using the wireless remote control>

▼Cooling test run:

ON/OFF → 64 °F (18 °C) → 66 °F (19 °C) → 64 °F (18 °C) → 66 °F (19 °C) → 64 °F (18 °C) → 66 °F (19 °C)

→64 °F (18 °C) → (test run) → ON/OFF

▼Heating test run:

ON/OFF → 86 °F (30 °C) → 84 °F (29 °C) → 86 °F (30 °C) → 84 °F (29 °C) → 86 °F (30 °C) → 84 °F (29 °C)

→86 °F (30 °C) → (test run) → ON/OFF

Always select
[HIGH] fan
speed.	3, 4,
2
2	5, 6
	2,7

EN

– 32 – 32-EN