3. Installing the Gateway
The gateway’s installation procedure will vary slightly depending on the chosen mounting method and the networks that will be used.
3.1 Mounting
3.1.1 Panel Mounting
The included standoff kit allows for panel mounting of the unit. The standoff kit is comprised of four 1” aluminum male/female standoffs and four #6 lock washers.
1.Remove one of the four cover standoff retention screws and its lock washer from the bottom side of the unit. DO NOT dispose of this screw and washer, as they will be used later to mount the unit to the panel.
2.Install one of the male/female standoffs and a #6 lock washer from the standoff kit through the unit’s circuit board and into the bottom of the cover standoff. Refer to Figure 1.
gateway unit | panel |
lock washers
lock washers and screws from step 1
aluminum standoffs
Figure 1: Standoff Kit Installation
3.Repeat steps 1 and 2 above to replace each of the three other cover standoff retention screws.
10