4.Using the dimensions provided in Figure 2, drill four 0.150” diameter holes at the specified locations on the panel. As a convenient pattern guide, the unit with attached mounting standoffs can be held against the panel, and the four standoff locations marked with a pencil or scribe.
3.5 IN
4.0 IN
2.9 IN
4.0 IN
Figure 2: Standoff Hole Placement
5.As shown in Figure 1, use the four screws and lock washers from step 1 to mount the unit from the back side of the panel.
3.1.2 SnapTrackTM Mounting
The unit footprint measures 4” x 4” square, and is designed to fit directly into existing 4” Augat SnapTrackTM (6TK series or equivalent). Carefully insert the unit into the SnapTrackTM by pressing firmly on the pan head screws located at the 4 corners of the unit’s cover. DO NOT press directly on the aluminum cover, as this may damage the cover.
3.1.3 DIN Rail Mounting
An optional mounting kit (ICC part number 10581) allows DIN rail mounting of the unit. The mounting kit is comprised of a 4” section of Augat 6TK SnapTrackTM and two DIN rail clips.
1.Carefully insert the unit into the SnapTrackTM by pressing firmly on the pan head screws located at the 4 corners of the unit’s cover. DO NOT press directly on the aluminum cover, as this may damage the cover.
2.Install the DIN rail clips into the openings on the bottom side of the SnapTrackTM. Refer to Figure 3.
11