TP-Link TL-WDR4300 manual Wireless 2.4GHz

TL-WDR4300N750 Wireless Dual Band Gigabit Router

These settings are only for basic wireless parameters. For advanced settings, please refer to

4.6 Wireless 2.4GHz.

7.Configure the basic parameters for 5GHz wireless network in the following screen as shown in Figure 3-13,and then click Next.

Figure 3-13 Quick Setup – Wireless

Wireless Radio - Choose from the drop-down list to enable or disable the wireless radio.

Wireless Network Name - Also called the SSID (Service Set Identification). Enter a value of up to 32 characters. The same name must be assigned to all wireless devices in your network. The default SSID is set to be TP-LINK_5GHz_XXXXXX. This value is case-sensitive. For example, TEST is NOT the same as test.

Region - Select your region from the drop-down list. This field specifies the region where the wireless function of the Router can be used. It may be illegal to use the wireless function of the Router in a region other than one of those specified in this field. If your country or region is not listed, please contact your local government agency for assistance.

Note:

Limited by local law regulations, version for North America does not have region selection option.

Band - This field displayed the operating frequency being configured.

Mode - This field determines the wireless mode which the Router works on.

11a only - Select if all of your wireless clients are 802.11a.

-17 -