TL-WDR4300N750 Wireless Dual Band Gigabit Router

Note:

To build a successful connection by WPS, you should also do the corresponding configuration of the new device for WPS function meanwhile.

I.Use the Wi-Fi Protected Setup Button

Use this method if your client device has a Wi-Fi Protected Setup button.

Step 1: Press the WPS/Reset button on the back panel of the Router, as shown in Figure 4-17.You can also keep the default WPS status as Enabled and click the Add device button in Figure 4-16.Then choose “Press the button of the new device in two minutes” and click Connect, shown in Figure 4-18.

Figure 4-17

Figure 4-18 Add A New Device

Step 2: Press and hold the WPS button of the client device directly.

Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup process.

Step 4: When the WPS LED is on, the client device has successfully connected to the Router.

Step 5: Refer back to your client device or its documentation for further instructions.

II. Enter the client device’s PIN on the Router

Use this method if your client device does not have the WPS button, but has a Wi-Fi Protected Setup PIN number.

Step 1: Keep the default WPS status as Enabled and click the Add device button in Figure 4-16,then Figure 4-19will appear.

- 38 -

Page 48
Image 48
TP-Link TL-WDR4300 manual Use the Wi-Fi Protected Setup Button, II. Enter the client device’s PIN on the Router