TP-Link TL-WDR4300 N750 Wireless Dual Band Gigabit Router,  Note, 6 PPPoE Advanced Settings

Models: TL-WDR4300

1 146
Download 146 pages 38.96 Kb
Page 36
Image 36
Figure 4-6 PPPoE Advanced Settings

TL-WDR4300

N750 Wireless Dual Band Gigabit Router

Note:

Only when you have configured the system time on “System Tools → Time Settings” page, will the Time-based Connecting function can take effect.

Connect Manually - You can click the Connect/Disconnect button to connect/disconnect immediately. This mode also supports the Max Idle Time function as Connect on Demand mode. The Internet connection can be disconnected automatically after a specified inactivity period and re-established when you attempt to access the Internet again.

Click the Connect button to connect immediately. Click the Disconnect button to disconnect immediately.

Caution: Sometimes the connection cannot be terminated although you specify a time to Max Idle Time because some applications are visiting the Internet continually in the background.

If you want to do some advanced configurations, please click the Advanced button, and the page shown in Figure 4-6will then appear:

Figure 4-6 PPPoE Advanced Settings

MTU Size - The default MTU size is “1480” bytes, which is usually fine. It is not recommended that you change the default MTU Size unless required by your ISP.

Service Name/AC Name - The service name and AC (Access Concentrator) name should not be configured unless you are sure it is necessary for your ISP. In most cases, leaving these fields blank will work.

ISP Specified IP Address - If your ISP does not automatically assign IP addresses to the Router during login, please click “Use IP address specified by ISP” check box and enter the IP address provided by your ISP in dotted-decimal notation.

- 26 -

Page 36
Image 36
TP-Link TL-WDR4300 manual N750 Wireless Dual Band Gigabit Router,  Note, 6 PPPoE Advanced Settings