TL-WR740N

Wireless Lite N Router

Chapter 2. Connecting the Router

2.1 System Requirements

¾Broadband Internet Access Service (DSL/Cable/Ethernet)

¾One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is connected directly to the Ethernet.)

¾PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

¾TCP/IP protocol on each PC

¾Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari

2.2 Installation Environment Requirements

¾Place the Router in a well ventilated place far from any heater or heating vent

¾Avoid direct irradiation of any strong light (such as sunlight)

¾Keep at least 2 inches (5 cm) of clear space around the Router

¾Operating Temperature: 0~40(32~104)

¾Operating Humidity: 10%~90%RH, Non-condensing

2.3 Connecting the Router

Before installing the Router, make sure your PC is connected to the Internet through the broadband service successfully. If there is any problem, please contact your ISP. After that, please install the Router according to the following steps. Don't forget to pull out the power plug and keep your hands dry.

1.Power off your PC, Cable/DSL Modem, and the Router.

2.Locate an optimum location for the Router. The best place is usually at the center of your wireless network.

3.Adjust the direction of the antenna. Normally, upright is a good direction.

4.Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on the Router, shown in Figure 2-1.(If you have the wireless NIC and want to use the wireless function, you can skip this step.)

5.Connect the DSL/Cable Modem to the WAN port on the Router, shown in Figure 2-1.

6.Connect the power adapter to the power socket on the Router, and the other end into an

- 6 -

Page 13
Image 13
TP-Link TL-WR740N manual System Requirements, Installation Environment Requirements, Connecting the Router