TP-Link TL-WR740N manual 2 WAN, Lan

TL-WR740N

Wireless Lite N Router

Figure 4-6 LAN

¾MAC Address - The physical address of the Router, as seen from the LAN. The value can't be changed.

¾IP Address - Enter the IP address of your Router or reset it in dotted-decimal notation (factory default: 192.168.1.1).

¾Subnet Mask - An address code that determines the size of the network. Normally use 255.255.255.0 as the subnet mask.

)Note:

a.If you change the IP Address of LAN, you must use the new IP Address to log in the Router.

b.If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the DHCP server will change accordingly at the same time，while the Virtual Server and DMZ Host will not take effect until they are re-configured.

4.5.2WAN

Choose menu “Network → WAN”, you can configure the IP parameters of the WAN on the screen below.

1.If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will automatically get IP parameters from your ISP. You can see the page as follows (Figure

4-7):

- 24 -