Uniden BCD536HP owner manual Set Dimmer BCD436HP Only High, Middle, or Low, Contrast, On or Off

10 sec - Turns the backlight on for 10 seconds when you press .

30 sec - Turns the backlight on for 30 seconds when you press .

60 sec - Turns the backlight on for 30 seconds when you press . Infinite - The backlight always stays on.

Set Dimmer (BCD436HP Only) High, Middle, or Low

Set Dimmer (BCD536HP Only)

Manual (For non-vehicle use) - High, Middle, Low, or Off.

Note: You can also toggle the backlight brightness by pressing Vol.

Auto (For vehicle use)

+ Polarity - If the orange wire gets 12V when you turn on the headlights.

-Polarity - If the orange wire is switched to chassis ground when you turn on the headlights.

Adjust Contrast – This setting controls the displays contrast.

Contrast 1-15

Display Unit ID – Allows you view the unit ID of the radio currently transmitting on Motorola, EDACS, and APCO P25 systems.

On or Off

Set ID Format – Sets the ID display format for the System.

Set ID Format (Mot/P25)

Decimal Format or Hex Format. The default setting is Decimal.

Set ID Format (EDACS)

AFS Format or Decimal Format. The default setting is AFS.

Set Upside-Down(BCD536HP Only) – This allows you to reverse the display so you can mount the scanner upside-down and hear the speaker from the top. The default setting is Off.

On or Off

Selecting 3-Line Display Mode

Hold on any channel and press Func then 9(DISP). Press Channel to resume.

3-Line Display O￿

27