Stop All Avoiding. See also Search Avoids.
At Confirm? Press E/yes or ./no.
Rvw Search Avoid
Scroll to Frequency and press E/yes to Stop Avoiding.
Broadcast Screen – Automatically ignores transmissions that are on common broadcasts, paging systems, and other annoyance radio sources during Custom Search, Quick Search, or Close Call Search. The default setting is Pager On.
Set All Band On/Off. Turns Broadcast Screen On or Off for All Bands.
Set Each Band
Scroll to each Band and press E/yes to enable or disable.
Program Band
Band
Set Lower Limit - Input the lower frequency limit.
Set Upper Limit - Input the upper frequency limit.
Press Menu to return and repeat for each band as needed.
Repeater Find – Sets whether the scanner tries to tune to a repeater output frequency when it detects a transmission on a repeater input frequency, in Search and Close Call modes. Turning this feature on can let you hear both sides of the conversation on the output frequency. The default setting is Off.
On or Off
Set Delay Time – Determines how long the scanner waits after a transmission ends before resuming Quick Search and Close Call Search operations.
A negative delay will force a resume after that number of seconds. The default setting is 2 seconds.
-10, -5, 0, 1, 2, 3, 4, 5, 10, or 30 sec.
Set Attenuator – This controls the attenuator for Quick Search, and Close Call operations by about 20dB. The default setting is Off.
On or Off
See also Search Attenuation.
Set Audio AGC – This allows you to turn AGC (Automatic Gain Control) on or off for Quick Search and Close Call modes. The default settings are Off.
Analog. Press E/yes to toggle On or Off.
Digital. Press E/yes to toggle On or Off.
P25 Waiting Time – This setting gives the scanner time to determine if frequencies have digital or analog transmissions. During this time, the scanner will evaluate the received signal and, if it detects digital data, will open squelch immediately. If digital is not detected before the delay expires, the scanner will open squelch at the end of this delay. This is to prevent “false decode” problems. The default setting is 400 ms.
0 to 1000 ms
Note: Any analog transmissions will lose the first part of the transmission, up to the wait time you set here.
P25 Threshold Mode – The default setting is Auto.
Auto. Automatically sets the decode threshold based on the received signal.
64
