Mounting Using ISO Technique

Some vehicles can take advantage of another approach to mounting a radio in a vehicle, called the ISO technique. However, this technique requires a very detailed and thorough knowledge of the technique. Therefore, we strongly suggest that if you have any doubt about your experience and abilities, please consult with a professional installer who is familiar with the ISO approach to radio installation.

To begin the process, it is first necessary to remove the scanners outer metal sleeve from the inner chassis. Unthread the four screws in the rear of the unit. Slide the cover toward the rear and off. Once the sleeve is removed, you will see threaded, metric machine screw holes on either side of the chassis cabinet. Uniden does not supply these screws. Their diameter, length, and screw type should be chosen by a qualified installer based on the internal vehicle bracket which will be used in securing the scanner chassis.

Once the original radio is removed from the vehicle dash and the fit of the scanner is correct, be sure to connect all the power, audio, antenna, and any other cables or wires, to the scanner before the scanner is secured.

The following illustration is a typical example of the ISO technique and the general side mounting screw holes often encountered. It does not actually represent the Uniden scanner or your vehicle’s mounting bracket. Only a professional installer will be able to determine the best and correct approach.

Connecting DC Cable with Orange Wire

Connect this cable to the vehicle’s electric system that receives power when you turn on your headlights. Now your scanner’s display will automatically dim when you turn on the headlights.

Using Internal Batteries (BCD436HP Only)

You can power your scanner using three alkaline or rechargeable AA batteries.

There is no switch for the battery type. Using non-rechargeable batteries, select “No” at the Battery message when connecting the USB cable.

1.Install 3 AA batteries, matching the polarity symbols (+ -).

2.Replace the cover.

When Battery icon flashes and the scanner beeps every 15 seconds, replace or recharge the batteries.

14

Page 22
Image 22
Uniden Using Internal Batteries BCD436HP Only, Mounting Using ISO Technique, Connecting DC Cable with Orange Wire