IMPORTANT INFORMATION
Please read this page carefully.
•ALL BOILERS MUST BE INSTALLED IN ACCORDANCE WITH NATIONAL, STATE AND LOCAL PLUMBING, HEATING AND ELECTRICAL CODES AND ORDINANCES, AS WELL AS THE REGULATIONS OF THE SERVING ELECTRICAL, WATER AND GAS UTILITIES.
•All systems should be designed by competent contractors, and only persons knowledgeable in the layout and installation of heating systems should attempt the installation of any boiler. It is the responsibility of the installing contractor to see that all controls are correctly installed and operating properly when the installation is completed.
•This boiler is intended for use, only with propane or natural gas. All flammable liquids (especially gasoline), chemicals, rags, paper, wood scraps, debris, etc., should be kept away from the boiler at all times. Keep the boiler area clean and free of all fire hazards.
•Please read the literature and warranties supplied by the manufacturers of the various accessory equipment. This equipment is warranted by the respective manufacturers, not by Quincy Hydronic Technologies, Inc. Each piece of equipment must be installed and used according to the recommendations of the manufacturer.
Codes and Regulations:
Installation of the boiler and related equipment must conform to national, state and local regulating agencies and codes applicable to the installation of the equipment. In the absence of local requirements, the following codes apply:
A. ANSI/NFPA | - #70 National Electric Code |
B. ANSI/NFPA | - #211 Chimneys and Vents |
C. ANSI/NFPA | - #Z223.1 National Fuel Gas Code |
C. ANSI/NFPA | - Domestic Gas Conversion Burner |
D. CAN/CGA | - B149 Installation Codes |
E. ANSI/ASME | - |
|
|
The above codes are available from: |
|
National Fire Protection Association (NFPA) | CSA International |
Battery March Park | 8501 E. Pleasant Valley Road |
Quincy, Massachusetts, 02269 | Cleveland, OH |
http://www.nfpa.org |
RIVA HEAT ONLY MANUAL - REV A | 8 |
