Vivotek IP8162 manual Hardware Installation, Hardware Reset

VIVOTEK

Hardware Reset

Status LED

Recessed Reset

Button

The reset button is used to reset the system or restore the factory default settings. Sometimes resetting the system can return the camera to normal operation. If the system problems remain after reset, restore the factory settings and install again.

Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the Network Camera to reboot.

Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that all settings will be restored to factory default. Upon successful restore, the status LED will blink green and red during normal operation.

SD/SDHC Card Capacity

This network camera is compliant with SD/SDHC 16GB / 32GB and other preceding standard SD cards.

Installation

Hardware Installation

Follow the steps below to mount the lens to the Network Camera:

1. Mount the lens by turning it clockwise onto the camera mount until it stops. If necessary, turn

the lens counterclockwise slowly until it gets the best attitude.

2. Connect the DC-iris control cable to the socket. (IP8162) Connect the P-iris control cable to the socket. (IP8162P)

1

2

8 - User's Manual