DTF521_Manual.fm Page 7 Tuesday, February 28, 2006 10:36 AM
PEN DISPLAY COMPONENTS
The LCD monitor and tablet sensor function as an integrated input and output device. The LCD monitor supports resolutions up to 1024 x 768 pixels at 16.2 million colors. The tablet sensor reports pen coordinates, pressure, and switch information.
Front view
On Screen Display (OSD) controls
These controls, located on the upper edge of the tablet, enable you to adjust a variety of display settings. See Adjusting the LCD monitor on page 24 for more information.
Power LED
Lights blue when power has been supplied to your pen display and a video signal is present.
Glows orange when no video signal is detected by the pen display. (e.g., Your computer is turned off, starting up, or has entered a power management mode in which video signals are not sent.)
Power switch
Turns power to the unit on or off.
Integrated LCD monitor and tablet
Pen tray
Provides a convenient resting place for the pen. When the display stand is set to its lowest position, place your fingers beneath the tray (located on the bottom front edge) and slide it out.
Status LED
Lights blue when the pen is in the active area of the pen display tablet and the pen tip or side switch are pressed. Note that the USB cable must also be plugged into an active USB port before the LED will light.
Use the integrated USB ports (one located on each side of the unit) to connect a USB device (e.g., a USB Flash Drive or a USB remote controller).
Be sure to fully install the pen display hardware and software before connecting any other devices to the unit.
Pen display components page 7
