Western Telematic PLS-345 manual Circuit Status Screen

Section 3: Quick Start / System Overview

Physical Layer Switch v1.00			Site ID:	PLS-345_TEST_IRVINE_CALIFORNIA
CKT#	From	To		POS MON Default
-----+	------------------	+------------------		+	-----	+	-----	+	---------
1	PORT_11111111111 PORT_BBBBBBBBBBB				B				A
2	PORT_22222222222 PORT_AAAAAAAAAAA				A		*		A
3	PORT_33333333333 PORT_AAAAAAAAAAA				A		*		A
-----+	------------------	+------------------		+	-----	+	-----	+	---------
Command Echo:		On
Inactivity Timeout:		30	Min
Command Confirmation:		On
Automated Mode:		Off
Monitor Mode:		On
Monitor Input Level:		1 - High

"/H" for help.

PLS>

Figure 3.1: The Circuit Status Screen

b)Modem Access: Start your communications program, and dial the number for the external modem. The PLS Circuit Status Screen (Figure 3.1) should be displayed, followed by the PLS> command prompt.

c)Console Port Access (Local PC): Start your communication program, make certain the communications program is set for the PC COM port that is attached to the PLS, and then press [Enter]. The PLS Circuit Status Screen (Figure 3.1) should be displayed, followed by the PLS> command prompt.

5.Review Help Menu: At the PLS> command prompt, Type /H and press [Enter] to display a help menu (Figure 3.2), which provides a basic listing of PLS commands.

3-3