Western Telematic PLS-345 manual Installation, Power Supply Connection, Initialization

4.Installation

4.1. Power Supply Connection

Connect the PLS-345 to an appropriate power supply.

CAUTIONS:

•This device should only be operated with the type of power source indicated on the instrument nameplate. If you are not sure of the type of power service available, please contact your local power company.

•Reliable earthing (grounding) of this unit must be maintained. Particular attention should be given to supply connections when connecting to power strips, rather than directly to the branch circuit.

•Check nameplate ratings to ensure that there is no overloading of supply circuits that could have an effect on overcurrent protection and supply wiring.

4.2.Initialization

If you are reinstalling a PLS-345 unit that has been previously installed, or if you wish to ensure that the PLS-345 is starting out with all parameters set in the default status, the PLS can be initialized to default values as described below.

Note: This initialization procedure will set all parameters to defaults, and will clear all user defined values such as network settings, and plug names.

1.Make certain that the PLS-345 Power Switch is set in the "Off" position.

2.Locate the Master A/B Switches on the unit's front panel. Press and hold the "A" button, and then press the Power Switch to the "On" position.

3.The Circuit Status Indicator LEDs will flash briefly, indicating that the unit has been reset to defaults. Release the "A" button.

4-1