View/Set Network Parameters | Western Telematic PLS-345 instruction

Section 10: Command Summary

/N View/Set Network Parameters

Displays the Network Parameters Menu (Figure 5.4), which is used to define the IP Address, Subnet Mask, Gateway Address and access the IP Security Menu. For more information on the Network Parameters Menu, please refer to Section 5.6.

Command Format: /N [Enter]

Response: Displays Network Parameters Menu.

Command Availability: System Only.

/M View/Set Monitor Mode Parameters

Displays the Monitor Mode Parameters Menu (Figure 5.6), which is used to enable and configure the Monitor Mode feature. The Monitor Mode allows the PLS to perform automatic A/B switching, based on the signal level of an RS-2323 line or contact connected to the Monitor Input Port. For more information on the Monitor Mode, please refer to Section 5.7.

Command Format: /M [Enter]

Response: Displays Monitor Mode Parameters Menu.

Command Availability: System Only.

/DL Download Configuration to File

Saves currently defined PLS configuration parameters to an ASCII file on your PC. This allows you to either "back-up" parameters as a safety measure, or download the parameters to another PLS-345 if several units will be configured with the same parameters. For more information on saving configuration parameters, please refer to Section 8.

Command Format: /DL [Enter]

Response: Prompts the user to configure terminal application to receive parameter file, waits for confirmation, and then downloads configuration parameters to an ASCII file on your hard drive when confirmation is given.

Command Availability: System Only.

10-3

Image 51

Western Telematic PLS-345 View/Set Network Parameters, View/Set Monitor Mode Parameters, DL Download Configuration to File

Contents

PLS-345 Page Shock Hazard Do Not Enter Nameplate Power Warning Ventilation Enclosed Racks Table of Contents Application Examples Command Summary Introduction Monitor Mode Applications Typographic Conventions Front Panel Unit Description Back Panel Back Panel Unit Description PLS-345 Physical Layer Switch Users Guide Quick Start / System Overview $ telnet 192.168.168.168 Enter Modem & Console Port Access Factory set PLS Circuit Status Screen Command Help Screen System Mode Installation Power Supply ConnectionInitialization Connecting a PC to the Console Port Connecting Common and A/B LinesConnecting the Network Cable Connecting an External Modem System Mode and User Mode SetUp and Configuration Communicating with the PLS-345 SetUp and Configuration PLS Command/Menu Conventions Defining General Parameters SetUp and Configuration PLS-345 Physical Layer Switch Users Guide SetUp and Configuration Circuit Parameters Menu Circuit Parameters Network Parameters Network Parameters Menu IP Security Implementing IP Security Example 1 Deny access to all hosts except Monitor Mode Hardware ConfigurationSelecting Monitor Mode Parameters Monitor Mode Parameters Menu Switch if Level 1 High Switch to Position B Return On Save Configuration Parameters Circuit Status Screen Status Screens PLS-345 Physical Layer Switch Users Guide Port Network Status Screen PLS-345 Physical Layer Switch Users Guide Operation Manual A/B Switching Enter Code Activated A/B Switching/A Command and the /B Command Enter or /B n Enter Command Confirmation Prompt /D Command Monitor Mode Sending Parameters to a File Saving and Restoring Configuration Parameters Restoring Saved Parameters Application Examples Monitoring Signal Drop and/or Power Loss AUX Port Connection Monitoring a Contact Monitoring a Switch or Relay Item 6 Circuits to Switch Enable the Monitor Mode at circuit Display Circuit Status Command SummaryDisplay Commands Display Help Screen View/Set Circuit Parameters Configuration CommandsSN Display Network Status View/Set General Parameters View/Set Monitor Mode Parameters DL Download Configuration to FileView/Set Network Parameters Control Commands Switch Circuit n to Line aSwitch Circuit n to Line B Command Format /T Enter Command Arguments Set Circuits to DefaultReset Network Interface Command Format /D Enter Command Arguments Exit/Disconnect Command Format /X Enter Command Arguments Interface Descriptions Console Port InterfaceModem Port Interface Figure A.3 Common Ports and A/B Ports Common Ports and A/B Ports Specifications SwitchingSize Trademark and Copyright Information Customer Service Index Index-2 Page Sterling Irvine California 949 586-9950 Toll Free