Network Parameters Menu | Western Telematic PLS-345 specs

PLS-345 - Physical Layer Switch; User's Guide

NETWORK PARAMETERS:
1.	IP Address:	65.106.93.114
2.	Subnet Mask:	255.255.255.0

3.Gateway Address: 65.106.93.97

4.IP Security

MAC Address:

52-54-40-22-48-7a

Enter Selection or <ESC> to Exit ...

Figure 5.4: The Network Parameters Menu

Note: Although new network port parameters can be specified via a network connection, newly selected parameters will not be applied until your telnet connection to the PLS has been terminated.

1.IP Address: Defines the IP Address for the PLS unit. Type 1, press [Enter] and follow the instructions in the submenu. (Default = 192.168.168.168.)

2.Subnet Mask: Defines the Subnet Mask for the PLS unit. Type 2, press [Enter], and follow the instructions in the submenu. (Default = 255.255.255.0.)

3.Gateway Address: Defines the Gateway Address for the PLS unit. Type 3, press [Enter] and follow the instructions in the submenu. (Default = undefined.)

4.IP Security: Sets up the IP Security feature as described in Section 5.6.1. (Default = undefined.)

5.MAC Address: Displays the unit's MAC address. Note that this item only displays the current address, and cannot be used to redefine the MAC address.

5-10

Image 28

Western Telematic PLS-345 manual Network Parameters Menu

Contents

PLS-345 Page Nameplate Power Warning Shock Hazard Do Not Enter Enclosed Racks Ventilation Table of Contents Command Summary Application Examples Monitor Mode Introduction Typographic Conventions Applications Unit Description Front Panel Back Panel Back Panel Unit Description PLS-345 Physical Layer Switch Users Guide Quick Start / System Overview Modem & Console Port Access Factory set PLS $ telnet 192.168.168.168 Enter Circuit Status Screen Command Help Screen System Mode Power Supply Connection InstallationInitialization Connecting Common and A/B Lines Connecting the Network CableConnecting an External Modem Connecting a PC to the Console Port SetUp and Configuration System Mode and User Mode Communicating with the PLS-345 SetUp and Configuration PLS Command/Menu Conventions SetUp and Configuration Defining General Parameters PLS-345 Physical Layer Switch Users Guide SetUp and Configuration Circuit Parameters Circuit Parameters Menu Network Parameters Network Parameters Menu Implementing IP Security IP Security Example 1 Deny access to all hosts except Hardware Configuration Monitor ModeSelecting Monitor Mode Parameters Monitor Mode Parameters Menu Switch if Level 1 High Switch to Position B Return On Save Configuration Parameters Status Screens Circuit Status Screen PLS-345 Physical Layer Switch Users Guide Network Status Screen Port PLS-345 Physical Layer Switch Users Guide Manual A/B Switching Operation Code Activated A/B Switching /A Command and the /B CommandEnter or /B n Enter Enter /D Command Command Confirmation Prompt Monitor Mode Saving and Restoring Configuration Parameters Sending Parameters to a File Restoring Saved Parameters Monitoring Signal Drop and/or Power Loss Application Examples AUX Port Connection Monitoring a Switch or Relay Monitoring a Contact Item 6 Circuits to Switch Enable the Monitor Mode at circuit Command Summary Display CommandsDisplay Help Screen Display Circuit Status Configuration Commands SN Display Network StatusView/Set General Parameters View/Set Circuit Parameters DL Download Configuration to File View/Set Monitor Mode ParametersView/Set Network Parameters Switch Circuit n to Line a Control CommandsSwitch Circuit n to Line B Set Circuits to Default Reset Network InterfaceCommand Format /D Enter Command Arguments Command Format /T Enter Command Arguments Command Format /X Enter Command Arguments Exit/Disconnect Console Port Interface Interface DescriptionsModem Port Interface Common Ports and A/B Ports Figure A.3 Common Ports and A/B Ports Switching SpecificationsSize Customer Service Trademark and Copyright Information Index Index-2 Page Sterling Irvine California 949 586-9950 Toll Free